Follow Us on LinkedIn Follow Us on YouTube

  1. CLR 1946 / CLH 6500

    Product is recommended for potting and encapsulating applications. A two component, room temperature cure semi-flexible epoxy system. The system was developed for potting / casting of electrical and electronic components. Its use of non abrasive fillers and convenient 1:1 ratio by volume, makes it ideal for use in machine dispensing equipment. CLR 1946 / CLH 6500

  2. CLR 3080 / CLH 6372

    General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372

  3. CLS 9420

    Structural Adhesive. This compound gels quickly at elevated temperatures with excellent adhesion to most substrates. A single component structural adhesive. This compound gels quickly at elevated temperatures with excellent adhesion to most substrates. CLS 9420

  4. CLS 9600

    High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600

  5. CLS 9611

    A low viscosity, single component, epoxy potting and encapsulating compound. The product has excellent stability and good adhesion to a wide range of substrates. This product meets UL 94-HB flammability requirements. Heat Cure Single Component semi-flexible epoxy potting and encapsulating system. Product is suitable for potting ferrites and pressure sensitive components in electrical and electronic applications. CLS 9611

  6. CLS 9616

    Heat Cure. Single Component semi-flexible epoxy potting and encapsulating system. Product is suitable for potting ferrites and pressure sensitive components in electrical and electronic applications. Low viscosity. The product has excellent stability and good adhesion to a wide range of substrates. This product meets UL94-HB flammability requirements. CLS 9616

  7. XR 11483 / CLH 6260

    Excellent fuel resistance. Suitable for automotive fuel sensors. A two component, chemical resistant epoxy casting system. The cured product has improved thermal conductivity for applications where heat dissipation from thermally sensitive devices is required. Cured product is resistant to Ethanol, Gasoline, and Diesel, when exposed to these chemicals at ambient or elevated temperatures. XR 11483 / CLH 6260

  8. XR 52092 / XH 62093

    1:1 machine dispense adhesive. Adhesive for bonding synthetic aggregates to metal. A medium viscosity, room temperature curing, two component epoxy adhesive. Product was developed with improved thin film set time when bonding metal substrates. XR 52092 / XH 62093

  9. XRD 1014 / XHD 1015

    High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015

  10. XRD 1018 / XHD 1019

    1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019

Results 21 - 30 of 30

Filters